9 materials · 16 calculators

Types of gravel: sizes, weights, prices and uses

The common types of gravel sort into clean stone that drains and graded stone with fines that compacts into a firm base. The table gives each type’s size, weight per yard, coverage per ton and published price, from the same sourced figures its calculator opens with.

Which gravel or stone do I need?

Start with the job. Materials that drain ( pea gravel, river rock, landscape rock, #57 stone, crushed stone) are clean or rounded stone with few fines: water runs through and they stay loose. Materials that compact (crusher run, road base, paver base, decomposed granite) carry fines that lock into a firm layer under a plate compactor or a roller. Then compare weight: the lightest preset here, #57 stone at 2,410 lb per yard, covers 89.63 ft² per ton at 3 inches; the heaviest, road base at 2,860 lb, covers 75.52 ft².

Types of gravel: size, calculator weight and published prices, before delivery
TypeSizelb per yd³ft² per ton at 3 inPublished price $/tonPublished price $/yd³BehaviourUsed for
Pea gravelAbout ⅜ in; often sold as AASHTO No. 8 (⅜ in to No. 8)2,70080$57 median · 6 lists$85 median · 6 listsDrainsPaths, patios and play areas; CPSC calls for 9 in under play equipment
River rockSold by size, from ¾ in to 5–12 in cobble2,65081.51$70 median · 5 lists$88 median · 4 listsDrainsBeds and dry creek beds, spread about one stone deep
Landscape rockVaries by product: ¾ in decorative rock, 1–3 in lava rock2,60083.08$74 median · 4 lists$75 median · 4 listsDrainsDecorative beds; lava rock weighs 36–60% as much per yard
#57 stone1 in to No. 42,41089.63$47 median · 3 lists$59.77 (1 list)DrainsDrain rock and stormwater reservoirs, about 40% voids by volume
Crushed stoneAASHTO No. 1 (3½ to 1½ in) to No. 10 (No. 4 to 0)2,80077.14$24.00–$49.50 (2 lists)$72 median · 3 listsDrainsClean stone sized by AASHTO number for drainage and sub-base
Crusher run1 in or 1½ in down to fines (VDOT No. 26 and No. 25)2,45088.16$55 median · 4 lists$54.22–$65.99 (2 lists)CompactsDriveway base and pipe bedding; fines bind it when compacted
Road base¾ to 2½ in top size down to fines, by state2,86075.52$40 median · 4 lists$99.99 (1 list)CompactsCompacted base under driveways and pads, in lifts of 6 in or less
Paver base¼ to ¾ in minus (top size down to fines)2,70080——CompactsUnder pavers: ICPI gives 4 in for walks and 6 in for driveways
Decomposed granite¼ in minus (granite grit down to fines)2,50086.4$43.00–$54.00 (2 lists)$120 median · 4 listsCompactsPaths and patios, at least 3 in compacted for foot traffic

Sizes quote AASHTO M43 where a standard size exists (as Florida DOT Section 901 prints it), state DOT gradings for crusher run and road base, and the product labels each calculator opens with for the rest. Weights are each calculator’s preset: one supplier’s published figure for one product, loose. A price is a median only where 3 or more price lists back it; with fewer, the listed price or range is shown with its list count, and “—” means we have no list in that unit yet. The per-ton and per-yard columns come from different sets of suppliers, so do not compare one column with the other; convert with the product’s weight per yard first.

Prices recorded September 23–24, 2026; see gravel prices for each source.

Gravel size chart: AASHTO numbers, inch sizes and local names

Crushed stone is sold by a size number as often as by inches. The numbers are AASHTO M43 standard sizes: each names the range of sieves the stone passes, from the largest opening down to the smallest it is retained on. “No. 4” is a sieve with 4.75 mm openings, about 3/16 in, so “1 in to No. 4” means stone between 1 in and 3/16 in with the fines screened out. Rounded gravel is sold by inches instead: pea gravel is about ⅜ in, and river rock by ranges such as 1–3 in or 2–4 in.

AASHTO M43 standard sizes as Florida DOT Section 901 prints them, with Pennsylvania’s names and an agency’s stated use where one is published
Size No.Nominal sizeLargest stonePennsylvania nameA published use
#13½ to 1½ in3.5 inPA #4—
#22½ to 1½ in2.5 in—stabilized construction entrances, stone reservoirs (Maryland Department of the Environment)
#242½ to ¾ in2.5 in——
#32 to 1 in2 inPA 3A—
#3572 in to No. 42 in——
#41½ to ¾ in1.5 in——
#4671½ in to No. 41.5 in——
#51 to ½ in1 in——
#561 in to ⅜ in1 in——
#571 in to No. 41 inPA 2Bstone reservoirs, around underdrains, under permeable paving (Maryland Department of the Environment)
#6¾ to ⅜ in0.75 in——
#67¾ in to No. 40.75 in——
#68¾ in to No. 80.75 in——
#7½ in to No. 40.5 in——
#78½ in to No. 80.5 in——
#8⅜ in to No. 80.38 inPA 1Bchip surfacing (Penn State Center for Dirt and Gravel Road Studies)
#89⅜ in to No. 160.38 in——
#9No. 4 to No. 160.19 in——
#10No. 4 to 00.19 in—structural fill, traction on ice; not a filter (Maryland Department of the Environment)

Sizes from Florida Department of Transportation (2010 workbook), Section 901, Table 1: Standard Sizes of Coarse Aggregate; Pennsylvania names from the Penn State Center for Dirt and Gravel Road Studies; uses from the Maryland Department of the Environment where it names one. The most common sizes have their own calculators: #57 stone, ¾ in crushed stone and pea gravel (#8).